Hardware questions from a newb.

Interfacing hardware, sensors, output drivers, chips.
Any Cal
Posts: 1
Joined: Sun Oct 25, 2009 5:01 pm

Hardware questions from a newb.

Post by Any Cal »

Hello,

I found the RBBB while searching for DIY camera remotes. I have some background in electronics, and soldering, but have never worked with anything like these before. Anyway, I would like to build a device that could use a radio signal to control the IR led at the specified timing, as well as have some additional functionality for various inputs.

Would the RBBB assembled kit and the USB BUB let me get started programming the chip for limited functionality, and then adding features as I learn? I am OK with enclosing the board and soldering/building inputs and outputs, but don't know anything about the programming side. I don't mind learning it, as long as I can be pointed in the right direction.

Am I looking at the right components? Do you have any other suggestions or helpful links?

Thanks for the time.

oz
Site Admin
Posts: 542
Joined: Mon May 12, 2008 4:19 pm

Re: Hardware questions from a newb.

Post by oz »

Sorry about the slow reply Any Cal,

All you need is a RBBB and a BUB (and a camera USB cable) to get going.

Driving LED's is dead simple with Atmel chips, whose outputs are good for up to 40 mA loads.

Paul

dwilbank
Posts: 2
Joined: Tue Nov 03, 2009 2:25 pm

Re: Hardware questions from a newb.

Post by dwilbank »

I'm even more a newb than you, but I think you wanted a tutorial.

Here are some that got me started. There are dozens more out there too.

http://www.earthshinedesign.co.uk/ASKMa ... anual.html
http://www.ladyada.net/learn/arduino/lesson0-win.html

Post Reply