I'm having problems trying to upload a sketch to my rainbowduino with the USB BUB. I'm kinda at a lost here so I'll just fill you in with everything I've done so far!
when I plug it in it flashes a couple really fast flashes then the yellow light shuts off then comes back on and stays on and about 20 seconds later I get the dreaded "not in sync" error?, at this point I should mention that I do get power from it and it does power the sketch that was previously loaded onto it. I decided to hook it up to the arduino and everything works/programs like it normally should. So I know I'm doing something right so I'm off to find the problem
I tried:
~ touching up/re-heating the solder points
~ switching the RSX/TX around.
~ switching ports, going to the advance driver settings and closing the RTS.
~ tried installing the drivers on a fresh computer using the USB BUB as the first hardware.
~ unplug the matrix from the rainbowduino.
~ pressing the reset button.
~ connected a jumper wire to the reset on the USB BUB although the rainbow takes DTR.
and I even talked nice to it telling it that it's not fat just big boned!!
any help would be appreciated.