Musk,
You are correct that the current sensor is extremely sensitive to position. Also consider making the wire slightly diagonal (askew) if that optimizes setting. We have measured currents that small in shop (11 watt compact flour. bulbs) very repeatably. One thing you can do is to average together several samples - perhaps up to 100 to average out jitter.
You should have gotten some mini zip ties with the sensor - but we weren't doing that in the early days. If you send email to sales @ modern device dot com with your address, we can put some in an envelope to you. Or you can pick them up at a home improvement store I imagine (but am not sure) I bought the ones we include online.
Paul
Current sensor @ low current (11w)
Re: Current sensor @ low current (11w)
Paul,
Thanks for the reply. (Also realized that I misstyped on = 0.07v dc ...should be 0.7v). Just wanted to let other readers know that a potential solution for detecting low current devices is to position the AC cord at the diagonal position (on top of each hall effect sensor) vs between the 2 hall effect sensors.
fyi: Did not mean to imply I didn't receive the zip-ties
.... my minor challange is securing the ac-cord in the "diagonal" position relative to the intended position (which should not be that difficult).
In my opinion your sensor is a well designed circuit with many practical applications.
Thanks for the reply. (Also realized that I misstyped on = 0.07v dc ...should be 0.7v). Just wanted to let other readers know that a potential solution for detecting low current devices is to position the AC cord at the diagonal position (on top of each hall effect sensor) vs between the 2 hall effect sensors.
fyi: Did not mean to imply I didn't receive the zip-ties
In my opinion your sensor is a well designed circuit with many practical applications.