Just a note that I am working on an application to detect if a device is on or off. The device draws about 11 watts at 120 vac per specifications. I am having a difficult time detecting current draw as expected. I noticed if I locate the power cord where each conductor was over each sensor (power cord at about 45 deg with respect to recommended position) I am able to observed a dc voltage diff when powered. On= ~ 0.070v ; off= 0.30v
Next step is to determine how to semi permanently secure my power cord to the sensor board at that position. Final step will be to interface sensor to a comparator then led indicator.
Current sensor @ low current (11w)
Re: Current sensor @ low current (11w)
Musk,
Your sensor should have come with mini zip ties, no? Maybe we weren't doing this in the early days of the sensor.
In any case mini zip ties make a good permanent joint, that can be undone at any times.
And yes, the output will vary with the location of the wire to the sensors. In particular, don't hesitate to put the wire at a slight diagonal if you get more output that way.
Paul
Your sensor should have come with mini zip ties, no? Maybe we weren't doing this in the early days of the sensor.
In any case mini zip ties make a good permanent joint, that can be undone at any times.
And yes, the output will vary with the location of the wire to the sensors. In particular, don't hesitate to put the wire at a slight diagonal if you get more output that way.
Paul