The result is a bit annoyingly hard to make sense of. There is a centering problem, where 0,0 is not the actual center; this can be fixed with calibration. But, once in a while, the readings go way out into the ether, as can be seen by the trails in the upper-right side, and sometimes they pull in towards the actual center of the measurement range.
As you can see, the compass is pretty far from anything with a strong magnetic field. The rover in the back is aluminum, and the motors are not energized; the leads are copper, and the wooden surface is all-wood joinery. The closest ferrous substance is proably the resistor leads in the plastic container bin in the background, so I don't think this is the issue.
What can I do to stabilize these readings? I use the default sensitivity of 1.3 Ga.

