Perhaps I haven't had enough coffee this morning, but it isn't obvious to me if the RHT02/DHT21 temperature/humidity sensor needs a pull-up resistor or not. It seems to work with one (I'm using 10K, based on the Lady Ada tutorial) but was hoping that it had one built in.
Thanks in advance, Doug
Does the RHT02/DHT21 need a pull-up resistor?
Re: Does the RHT02/DHT21 need a pull-up resistor?
You can also use built in pin pullups on micrcrocontrollers that support pin pullups,
e.g. most modern microcontrollers
Paul
e.g. most modern microcontrollers
Paul