Page 1 of 1

How to Connect And Program The FluxamaSynth For Cubloc??

Posted: Thu Aug 16, 2012 2:50 pm
by LESTROSO
Dear Sirs,

It arrived to me the fluxamasynth shield...but i have some problems...

1) I connect my cubloc with p11the serial out...the serial 5v pilot.. to the port number 1 the rx midi in of fluxamasynth...throught a 220ohm resistance, as shown in the manual...

For now i have turn on the circuit and i see the diode red light -on......

2) do you know some examples to pilot in basic language for my Cubloc 220???

3) The baud rate of midi is not the same of classical serial rs232 5v , i saw the midi must go about 32250 baud...

4) what about an example in basic to play a simple note???

Can someone Help me Please???

Best Regards,

Lestroso :oops:

Re: How to Connect And Program The FluxamaSynth For Cubloc?

Posted: Fri Aug 17, 2012 12:15 pm
by oz
Send me some links to the docs on your programming language.
Are there bitwise commands available?

Paul

Re: How to Connect And Program The FluxamaSynth For Cubloc?

Posted: Mon Aug 20, 2012 5:14 pm
by LESTROSO
Dear Paul,

I have sent to you the manual doc about cubloc220.

The language is easy is basic....

I thank you a lot for your time dedicated to me...

i look forward to your reply..

Best Regard,

lestroso (Saverio) :oops: