Page 1 of 1

Multiple I2C devices on JeeNode?

Posted: Mon Sep 12, 2011 2:55 pm
by maurice
I have the Modern Device SHT21 temperature/humidity on a JeeNode. There is no schematic for that sensor board but it appears that it has a regulator and mosfet level shifters possibly to accommodate a 5V microprocessor interface.
I'd like to add a second I2C device and I was wondering if there were pullups and what their values were so I dont double up.
Anyone else used multiple I2C devices on a JeeNode? Any tips?

Re: Multiple I2C devices on JeeNode?

Posted: Thu Sep 15, 2011 5:03 pm
by maurice
It turns out not to be a significant problem. I have the Sparkfun BMP085 and Modern Device SHT21 board both hanging off the Jeenode I2C bus and can access them both without any problems. I'm guessing the pullups in parallel produce a load of about 2.2K which is still light enough for the output drivers.
If you are interested the temperature reported from the SHT21 and the BMP085 are within about 0.4F of each other, which is good enough for me.