Frequency to Voltage Conversion
Posted: Mon Sep 15, 2008 8:22 pm
Hey Guys,
Very new at this and I am getting ready to order my first arduino. I have been doing tons of reading and I have a few projects in mind.
First project-
I would like to take the signal from a VR sensor (ABS sensor in this case) and use a look up table on the ardunio to convert it to a linear voltage output. This would be in turn used as an input into an EMS. I realize that this could be done strictly with analog hardware but I want to give it a shot with the Arduino first and get my feet wet.
Second Project -
I want end up recieving and logging the data from my EMS for later analysis. I know that all I have to do is send it an "a" followed by a binary number to tell it what data I want. Then it will send me back all the raw binary data which I want to log. My question is, how well can I store this raw data on to a removeable storage medium such as an SD card or the like.
I know that the second project is getting a little deep for a beginner but when I have something that interests me, it will help keep me focused and determined. I appreciate any and all input and advice you guys have to offer me.
Thanks,
Caleb Peterson
4th Year Mechanical Engineering Student
Rochester Institute of Technology
Very new at this and I am getting ready to order my first arduino. I have been doing tons of reading and I have a few projects in mind.
First project-
I would like to take the signal from a VR sensor (ABS sensor in this case) and use a look up table on the ardunio to convert it to a linear voltage output. This would be in turn used as an input into an EMS. I realize that this could be done strictly with analog hardware but I want to give it a shot with the Arduino first and get my feet wet.
Second Project -
I want end up recieving and logging the data from my EMS for later analysis. I know that all I have to do is send it an "a" followed by a binary number to tell it what data I want. Then it will send me back all the raw binary data which I want to log. My question is, how well can I store this raw data on to a removeable storage medium such as an SD card or the like.
I know that the second project is getting a little deep for a beginner but when I have something that interests me, it will help keep me focused and determined. I appreciate any and all input and advice you guys have to offer me.
Thanks,
Caleb Peterson
4th Year Mechanical Engineering Student
Rochester Institute of Technology