FTDI cable problems under Vista+SP1?
Posted: Fri May 16, 2008 6:18 pm
Hi:
I had been using an FTDIUSB to serial cable successfully with my Compaq Presario F572US laptop to connect to BBB's. Works fine under XP, of course, and initially under Vista, but after "upgrading" my Vista to SP1 I am unable to use the FT232-based cable.
(The upgrade was an attempt to fix a problem with the wireless support, which I eventually fixed through an unrelated registry patch).
Vista claims its internal driver is optimal, but it doesn't find any appropriate settings for IRQ and IO address. All attempts to install the FTDI driver downloaded from here (http://www.ftdichip.com/Drivers/CDM/CDM ... tified.zip) fail. I've attempted to install this driver both using the "upgrade driver" feature from Device manager, and via the setup executable from the FTDI web pages. Either the serial port device does not show up at all in Device Manager, or it shows up, disabled with invalid settings.
Anyone else had this problem (yet) or found a workaround?
Jerry
I had been using an FTDIUSB to serial cable successfully with my Compaq Presario F572US laptop to connect to BBB's. Works fine under XP, of course, and initially under Vista, but after "upgrading" my Vista to SP1 I am unable to use the FT232-based cable.
(The upgrade was an attempt to fix a problem with the wireless support, which I eventually fixed through an unrelated registry patch).
Vista claims its internal driver is optimal, but it doesn't find any appropriate settings for IRQ and IO address. All attempts to install the FTDI driver downloaded from here (http://www.ftdichip.com/Drivers/CDM/CDM ... tified.zip) fail. I've attempted to install this driver both using the "upgrade driver" feature from Device manager, and via the setup executable from the FTDI web pages. Either the serial port device does not show up at all in Device Manager, or it shows up, disabled with invalid settings.
Anyone else had this problem (yet) or found a workaround?
Jerry