TAT questions
Posted: Sun Mar 06, 2011 11:03 pm
So the TAT's recommended minimum voltage is 4 volts according to the website.
I'd like to use the TATs with a TI MSP430-2500 wireless board which with their included battery holder puts it's operating voltage at 3v using new alkaline AAA batts. So what are the implications of using the TAT at such a low voltage?
Also if I were to boost the supply to 5v and had it calibrated for .5v at zero wind, at what wind strength might the TAT reach 3v?
I'm only planning on using these with a max of 20mph wind outdoors. i.e. when the wind hits 15, I shut things down till things settle down...
I'd like to use the TATs with a TI MSP430-2500 wireless board which with their included battery holder puts it's operating voltage at 3v using new alkaline AAA batts. So what are the implications of using the TAT at such a low voltage?
Also if I were to boost the supply to 5v and had it calibrated for .5v at zero wind, at what wind strength might the TAT reach 3v?
I'm only planning on using these with a max of 20mph wind outdoors. i.e. when the wind hits 15, I shut things down till things settle down...