Page 1 of 1

Wicked Device RBBB shield does not work with Ethernet shield

Posted: Fri Feb 18, 2011 1:46 am
by ramgui
Are there compatibility issues with the Wicked Device proto shield and the new Ethernet shield with microSD?
None of the example sketches for the Ethernet shield works on it. I also have a Duemilanove and all the examples run just fine with it.

Re: Wicked Device RBBB shield does not work with Ethernet sh

Posted: Fri Feb 18, 2011 4:12 pm
by ramgui
Ok, after reviewing the schematic of the Arduino Ethernet shield V5, I found out that the ICSP 6 pin connector which is not available on the WickedDev is required for the shield to work. The SCK, MISO,MOSI and SS are floating on the ethernet shield without the 6 pin connector.
I jumpered the 6 pin connector on the ethernet shield to the appropriate pins ( pins 13,12,11 and 10) on the WickedDev and all seems well.
I guess on the next version of the proto board, this modification should be addressed.