ESP32 Synth. command not working
Posted: Tue Jul 04, 2023 10:41 pm
Hello,
I've been using the fluxamasynth arduino shield for a project, and it has worked great. I decided to try the ESP platform for the smaller package and additional features. Currently I have confirmed the chip is working by uploading a blink code on one of the pins.
After that, I tried copying over my arduino code. It compiles fine, but gets stuck during runtime when the synth. command is called.
For example, this is my main loop
With the following setup, I can see the blink on this pin. However, as soon as I uncomment the synth. commands, the program hangs at runtime. If I call the synth. command in the loop instead of setup, I get the same result.
I've tried different methods of creating the synth object. I've verified that my Fluxamasynth.h file is updated to include esp platform. Any other things that I could check?
Thanks for any help
I've been using the fluxamasynth arduino shield for a project, and it has worked great. I decided to try the ESP platform for the smaller package and additional features. Currently I have confirmed the chip is working by uploading a blink code on one of the pins.
After that, I tried copying over my arduino code. It compiles fine, but gets stuck during runtime when the synth. command is called.
For example, this is my main loop
Code: Select all
void loop() {
digitalWrite(debug, HIGH);
delay(1000);
digitalWrite(debug, LOW);
delay(1000);
}Code: Select all
#include <Fluxamasynth.h>
#include <PgmChange.h>
#include"pitches.h"
//Fluxamasynth synth; // create a synth object
Fluxamasynth synth = Fluxamasynth();
byte instrument = 0;
int volume = 0;
int debug = 32;
void setup() {
pinMode(debug, OUTPUT);
*/
synth.setMasterVolume(volume);
synth.programChange(0, 0, instrument);
*/
}Thanks for any help