Page 1 of 1

Taking wind sensor off Rev P board

Posted: Sat Mar 13, 2021 1:57 pm
by hfrebel
Hello
for my project I'd like to remove the board sensor (I ordered Rev P), and replace it with an external thermistor connected by leads. I expect this would require recalibration, that's fine. What sort of specification for the thermistor should I be looking for?
Regards
S

Re: Taking wind sensor off Rev P board

Posted: Sat Mar 13, 2021 3:59 pm
by oz
Send your address to support@moderndevice.com and we’ll send you some sensors.


The BOM is not public

However adding leads will change the way it works just a bit too, adding some thermal resistance.

I’d rather see you cut off the sensing stalk and resolder those wires back together - and I think it will be slightly less pain - but maybe not

You need 30 ga wire and some patience along with soldering skills.
Use a utility knife and patience to cut through the board between the headers
Use patience - don’t try to cut through on one go - just a ruler and lots of little passes.

Paul Badger

Re: Taking wind sensor off Rev P board

Posted: Sun Mar 14, 2021 5:08 am
by hfrebel
Legendary! Thank you very much

S