Wind Sensor Rev.P usage questions
Posted: Mon Mar 12, 2018 9:52 am
Hi, I am using a Wind Sensor Rev.P with an Arduino MEGA 2560 R3. I am powering the sensor from 12.4V. I have noticed with the sensor sitting on my desk in a breadboard, oriented vertically, I regularly see speeds around 1.22 mph without any fans operating. With an 80mm DC fan operating, I see around 10 mph. The temperature reported by the sensor is always in the range of 40C or higher.
1. What is that temperature reading? I am wondering if it is due to the vertical orientation and something on the PCB heating the rising air below, or if it is actually measuring the temperature of a heated element on the sensor itself. i.e. should that sensor be showing me the actual room temperature, which is 24C?
2. I read in the blog here that someone was working on a temperature/humidity correction for this sensor, but I can't find anything else that shows how I might implement that. Has anyone actually finished that project?
3. My final question is about housing this sensor for use. I plan to use this sensor near a 4" diameter PVC exhaust pipe operating at 130 cfm. Which parts of this sensor need to be exposed? I am thinking only the loop and the thin "mast" next to it (for lack of a better word) need to be placed in the air stream, and I should be able to enclose the rest of the PCB in a small 3d printed housing similar to a USB stick. Does that seem correct?
Thanks,
Dan
1. What is that temperature reading? I am wondering if it is due to the vertical orientation and something on the PCB heating the rising air below, or if it is actually measuring the temperature of a heated element on the sensor itself. i.e. should that sensor be showing me the actual room temperature, which is 24C?
2. I read in the blog here that someone was working on a temperature/humidity correction for this sensor, but I can't find anything else that shows how I might implement that. Has anyone actually finished that project?
3. My final question is about housing this sensor for use. I plan to use this sensor near a 4" diameter PVC exhaust pipe operating at 130 cfm. Which parts of this sensor need to be exposed? I am thinking only the loop and the thin "mast" next to it (for lack of a better word) need to be placed in the air stream, and I should be able to enclose the rest of the PCB in a small 3d printed housing similar to a USB stick. Does that seem correct?
Thanks,
Dan