Page 1 of 1
RBBB with ATMega328p ?
Posted: Fri Jul 18, 2008 6:33 am
by mdAndy
The Atmel AVR ATMeaga128p is a 28 pin device with 16K flash 1K Ram 1/2K EEProm.
The Atmel AVR ATMeaga328p is a 28 pin device with 32K flash 2K Ram 1K EEProm.
How about it?
Re: RBBB with ATMega328p ?
Posted: Fri Jul 18, 2008 4:23 pm
by oz
I'll look into these chips. I think Lady Ada was talking about the 323 and expected the Arduino IDE to support it. Not shipping till fall though I think.
Paul
Re: RBBB with ATMega328p ?
Posted: Fri Jul 18, 2008 6:32 pm
by mdAndy
Paul, it is the second chip I am talking about - The first chip goes on your standard RBBB and is the ATMega168p chip.
The second chip has "double the resources" of your Freeduino chip.
Re: RBBB with ATMega328p ?
Posted: Fri Jul 18, 2008 6:36 pm
by mdAndy
mdAndy wrote:The Atmel AVR ATMeaga168p is a 28 pin device with 16K flash 1K Ram 1/2K EEProm.
The Atmel AVR ATMeaga328p is a 28 pin device with 32K flash 2K Ram 1K EEProm.
How about it?
Re: RBBB with ATMega328p ?
Posted: Sat Jul 19, 2008 10:39 pm
by oz
Yes it's the 328P. The datasheet shows a DIP package but no signs of it at Digikey.
I don't think this ships until fall.
It should just drop into BBB and RBBB as far as I can see, and the price is only .30 more than the 168 chips so it should be an easy upgrade once David Mellis and the hard core programmer gang get the IDE changes sorted out to support it. I wouldn't be surprised to seem some efforts to support other chips too, such as the tiny (AT) series.
Paul