Page 1 of 1

attaching LEDs to RBBB

Posted: Tue Nov 03, 2009 2:46 pm
by dwilbank
Hi.
This is my first project so I don't know what pieces I need next.

I want to connect some LEDs to the analog pins which are conveniently sticking out from the bottom of my RBBB.

Should I be looking for a little plastic plug which would fit over these pins and give me loose wires on the other end?
Or is it normal practice to stick the whole RBBB in a breadboard and solder the LED leads beneath the breadboard?
Or do I clip the pins I don't need, bend the ones I want outward, and solder them directly to the LED leads?

Thanks for any tips.

Re: attaching LEDs to RBBB

Posted: Thu Nov 05, 2009 10:19 pm
by oz
I have to say that all of your ideas will work electrically, and someone has probably done them all over the years. You can directly light an LED from an Atmel pin, which will supply around 40 mA. This probably stresses the pin a bit, but I've done it plenty with no ill effects. You may not wish to do this if you are lighting more than the 6 LEDs though. In that case I'd recommend some series resistors.

Be aware that the analog pins - are for analog INPUT - and although you can use them to light LEDs, if you're trying to FADE LEDs, then you should use one of the pins marked "PWM" on the BBB board, on the index page. They're the same on RBBB - just no room for lablels

Paul