Daisy chaining power
Posted: Mon Nov 02, 2009 4:45 pm
The documentation for the boards recommend wiring every other board to power and daisy chaining the intermediate boards. My question is if there is any reason why I couldn't connect each board to a power source individually and not daisy chain at all?
To clarify this a little bit, I have four fully assembled boards and I'm running power from a regulated 5v 6amp power supply and I'd like to standardize each board and make a sort of power strip to distribute power from the supply to each board.
Thanks!
To clarify this a little bit, I have four fully assembled boards and I'm running power from a regulated 5v 6amp power supply and I'd like to standardize each board and make a sort of power strip to distribute power from the supply to each board.
Thanks!