Page 1 of 1
current sensors
Posted: Sat May 14, 2016 10:00 am
by avgreg46
i was just wondering if anyone has a suggestion for a simple clamp type 120v 0-50amp current sensor that i can use for a 120v on/off switch.
Re: current sensors
Posted: Fri Dec 02, 2016 6:52 pm
by oz
avgreg46,
Our sensor will work really well for this (it's really easy to sense 50 amps right through a line cord) but you'll need to hook it up to a solid state relay - and also to some kind of DC power source. It would be fairly easy to hook the output up to a solid state relay without a microcontroller, if you were just looking for go-no go at 50 amps.
Paul
current sensors
Posted: Wed Oct 04, 2017 7:07 pm
by Sonovkwf
How would one connect multiple current sensors?
I am using two 50 A sensors. One on the output of the alternator and one on the output of the battery. I know I can connect one of them to the EIS and assume the other one will also be connected to the EIS.
Will I be able to monitor both current output information on the HX?