Page 1 of 1
Pressure Sensor
Posted: Thu Oct 09, 2014 12:12 pm
by Don
Hi,
What connections must be made to the MPXV differential pressure sensors (Analog Output)? Which pins (if any) can (must?) be left unconnected?
Thanks, Don
Re: Pressure Sensor
Posted: Fri Nov 07, 2014 8:46 am
by oz
Don,
You've probably figured this out long ago. (Sorry about the really slow reply)
There are only three lines on the pressure sensor GND +V (5V) and the Vout line. The other pins are more for mechanical stability and all the pins are in parallel. If you use a meter on continuity you can confirm that.
Hope that helps,
Paul
Re: Pressure Sensor
Posted: Fri Nov 07, 2014 11:32 pm
by Don
Yes it does, thanks. The pins are labelled clearly enough. I was just being cautious with the extra pins--didn't want to ruin my sensor. However I did go ahead and try it and it works fine.
Don