Page 1 of 1

USB BUB board to wiring mini?

Posted: Mon Mar 23, 2009 1:53 pm
by Starfire
Didn't really know where to post this, but can the USB BUB board be used to connect and program the Wiring mini?

Thanks!

Re: USB BUB board to wiring mini?

Posted: Mon Mar 23, 2009 2:09 pm
by oz
I'm not familiar with Wiring Mini.
Do you mean Arduino mini? or is there a new product out there I'm unaware of?
I checked sparkfun but maybe didn't try hard enough.

But the short answer is that I'm sure that it can - either in the default setup or by remapping the pins to the required order on the auxiliary header.

Paul

Re: USB BUB board to wiring mini?

Posted: Mon Mar 23, 2009 3:21 pm
by Starfire
Here is a link - http://www.wiring.org.co/hardware/wiringmini.html

and a PDF schematic - http://www.wiring.org.co/download/WiringMini.pdf


It's the small version of the full Wiring board.

Re: USB BUB board to wiring mini?

Posted: Thu Apr 02, 2009 7:19 am
by oz
Sorry for the slow reply, I still haven't been able to get my forum to notify about every post.
Yes the bub will work fine for this for the RX/TX connection. Don't forget BUB TX goes to chip RX - it's OK to swap them if you're confused you won't hurt anything swapping RX and TX lines.

Before you hook up any power lines though, confirm that the mini is running on 5V's. It it's at 3.3V then you'll need a regulator to drop the voltage - or just use an external power supply for the mini - and tie the BUB and mini grounds together. The BUB's 50 mA 3.3V supply is probably enough to program the mini, but not enough to have much fun with all those pins!

Paul