Burning Bootloader/Uploading Sketches To JeeNode Micro

[BobCochran10]

Has anyone succeeded in burning a bootloader to the JeeNode Micro? I believe I followed the toolchain setup described here:

http://jeelabs.org/2013/03/21/programmi ... 5-at-last/

But I when I try to burn the bootloader, I get an error message:

Error while burning bootloader: missing 'erase.params.verbose' configuration parameter

A screen shot of my Arduino screen is uploaded as an attachment, and hopefully I can also upload a photo of the hardware.

I have a BUB II board set to 3.3v logic which is connected to a JeeNode v6 board. On top of this is the JeeNode flash board. The flash board is connected to the JeeNode Micro.

[attachment=1]Arduino_1.5.4.larger_screen_bootloader_error_jeenode_micro.png[/attachment]

[attachment=0]jeenode_micro_programmer_array_edited_small.jpg[/attachment]

Thanks for any help!

Bob Cochran
Greenbelt, Maryland, USA

[BobCochran10]

This thread

http://jeelabs.net/boards/7/topics/2986?page=1&r=3259

which continues, gives the details of programming a bootloader to the JeeNode Micro and points the reader to a fork of jcw/ide-hardware on GitHub that contains corrected code and additional documentation. Apparently, however, a bootloader is pointless for the ATTINY84. See the comments by wolfpackmars2 and JohnO in the thread. Both contributors are more experienced with JeeNodes than me.

The challenge of uploading a sketch to the JeeNode Micro also gets attention.

Happy Thanksgiving!

Bob