SOLVED: USB BUB II Not Working
Posted: Thu Aug 08, 2013 10:01 pm
Got my package of two jeenodes and a usb bub II this afternoon, I'm excited to try them out!
BUT, my usb bub II doesnt seem to be working.
When I first plug the board in it the Rx and Tx leds flash briefly then no other kind of response.
I've tried it in both windows 7 and ubuntu 12.10, neither operating system even see's that it's connected.
My multimeter is reading 5v on power and 3v on rx/tx pins.
Like I said neither operating system seems to know it's even there. Not to mention arduino IDE. (Serial monitors were tried on all baums and Arduino uno board, though I think this is moot at this point.)
Every time I unplug then plug the bub into the usb the leds flash very briefly then no responses afterward.
In my excitement when my packages were delivered I went soldering crazy building the jeenodes then the bub. I did attach the jumper headers on the bub. But before I powered the bub up I double checked the instructions to discover I didn't need to do that. So the jumper pin headers are attached but I didn't put the jumpers on the pins. I left the pre-soldered jumps as-is. Could this be part/all of my problem? Have I fried this thing?
***** UPDATE
My usb cable was bad, switched cables on a whim and everything is working as it should.
BUT, my usb bub II doesnt seem to be working.
When I first plug the board in it the Rx and Tx leds flash briefly then no other kind of response.
I've tried it in both windows 7 and ubuntu 12.10, neither operating system even see's that it's connected.
My multimeter is reading 5v on power and 3v on rx/tx pins.
Like I said neither operating system seems to know it's even there. Not to mention arduino IDE. (Serial monitors were tried on all baums and Arduino uno board, though I think this is moot at this point.)
Every time I unplug then plug the bub into the usb the leds flash very briefly then no responses afterward.
In my excitement when my packages were delivered I went soldering crazy building the jeenodes then the bub. I did attach the jumper headers on the bub. But before I powered the bub up I double checked the instructions to discover I didn't need to do that. So the jumper pin headers are attached but I didn't put the jumpers on the pins. I left the pre-soldered jumps as-is. Could this be part/all of my problem? Have I fried this thing?
***** UPDATE
My usb cable was bad, switched cables on a whim and everything is working as it should.