Q 1 Can I situate the synth in the same position as the ethernet board on the mega?
Q.2 Can I take the center pin on the pin select for the external serial and wire it to one of the other hardware serial ports on the Mega?
Thanks in advance
Charles Burnaford
Fluxamasynth and Arduino Mega
Re: Fluxamasynth and Arduino Mega
Charles,
and serial in from the arduino board - so if the power pins mate with traditional power pins, you're good to go.
other pins & shunts. Some of out shop lashups work this way.
Paul
I'm not quite following that - the synth board only really picks up 5V power (it has 3.3V regulator on board)Q 1 Can I situate the synth in the same position as the ethernet board on the mega?
and serial in from the arduino board - so if the power pins mate with traditional power pins, you're good to go.
Most definitely -- use any pin you want and just define the TX pin in the library examples - route that pin to the middle pin of the fluxamasyth and ignore theQ.2 Can I take the center pin on the pin select for the external serial and wire it to one of the other hardware serial ports on the Mega?
other pins & shunts. Some of out shop lashups work this way.
Paul
Fluxamasynth and Arduino Mega
I just picked up a Mega ST2 and found your post. Great read The photos are wonderful. Thanks