DIO

Requests for new features and products, news about what we are working on.
Post Reply
jismagic
Posts: 1
Joined: Sun Oct 06, 2013 1:14 am

DIO

Post by jismagic » Sun Oct 06, 2013 1:44 am

Hello guys,

Here is something i wanted to do and im confused how to proceed.
Need your expert advice.

Requirement : Need a 32 Digital IO output which can source and sink approx 100mA per output. The output voltage can be in the range 5-18V. There are 3 states - a high state , a low state and an open state. All 32 DIOs can be either an output or an input- (source or sink) and i need to configure it from my Windows PC. The solution im looking for need to be within 150 USD or a max of 200USD. The rpice is excluding the power supply.

My thoughts:

Use an Arduino board and expand the digital out to 32 with shift register. Pass it through a darlington pair and then a analog crosspoint switch.
Challenges: a. Crosspoint switch which can handle 100mA per output.
b. Handle high, low and open with one switch.

Please advise.
jis

paul
Site Admin
Posts: 706
Joined: Mon May 12, 2008 4:19 pm

Re: DIO

Post by paul » Mon Nov 25, 2013 11:13 pm

jismagic,

Sorry about the REALLY slow reply. Sorry to sound like a broken record but phpbb is kind of nightmare for me in the back end.
Did you find the chip/s of your dreams?
Or roll your own solution. I would have started looking at tri-state buffers,
seems like there must be something out there. Hooking up half bridge drivers would probably have been the next step.

Paul

Post Reply