Programming question.

Questions about the Really Bare Bones Board
Post Reply
Visigoth
Posts: 2
Joined: Tue Aug 25, 2009 4:05 pm

Programming question.

Post by Visigoth »

I own an Arduino Diecimila board. I just purchased an RBBB kit from Modern Device. Can I pop the ATmega168 chip into the Diecimila socket, program it, and then put it back in the RBBB kit to run? Or do I have to buy the programming cable?
floresta
Posts: 93
Joined: Mon Jul 28, 2008 6:52 pm
Location: Western New York, USA
Contact:

Re: Programming question.

Post by floresta »

Visigoth
Can I pop the ATmega168 chip into the Diecimila socket, program it, and then put it back in the RBBB kit to run?
That would work but I wouldn't do it too often because of the wear and tear on the IC sockets.
Or do I have to buy the programming cable?
If you go this route I would suggest the USB BUB board, USB to TTL serial adapter which more closely replicates the Arduino configuration.

Don
Visigoth
Posts: 2
Joined: Tue Aug 25, 2009 4:05 pm

Re: Programming question.

Post by Visigoth »

Thank you. Is the clock speed different between the two?
floresta
Posts: 93
Joined: Mon Jul 28, 2008 6:52 pm
Location: Western New York, USA
Contact:

Re: Programming question.

Post by floresta »

No, the clock speeds are the same - 16 MHz. Any device that is, or claims to be, Arduino compatible must run at this speed otherwise it wouldn't really be compatible.

Don
Post Reply