Waterproofing Wind Sensor Rev. P
Posted: Thu May 16, 2019 3:40 pm
Hi, I need to measure wind speed on a small sail boat using the Wind Sensor Rev. P.
The problem is that the boat can tip and the sensor can end up in the water for some time.
I was wondering if it is possible to make the sensor waterproof. My plan is to use Silicone Modified Conformal Coating by MG Chemicals on the whole board but I don't know if this can compromise the correct working of the sensor.
The problem is that the boat can tip and the sensor can end up in the water for some time.
I was wondering if it is possible to make the sensor waterproof. My plan is to use Silicone Modified Conformal Coating by MG Chemicals on the whole board but I don't know if this can compromise the correct working of the sensor.