Having an issue getting any reading from Rev. P sensor
Posted: Mon Apr 16, 2018 11:44 am
I am not able to get any sort of a reading on my Rev. P sensor using an Arduino Leonardo. The readings i am getting go from Nan to 1551 mph, and the temperature always stays around -25 degrees C. I am powering the sensor using a 12 volt DC signal rectified from 240V AC (i am the computer engineer on this project so if more details on the circuitry are needed i can ask my electrical engineer). I am not sure where to start trouble shooting, could it be how it is getting power? I heard some people say it could be how it is grounded? Any help would be appreciated.