A1324 Hall Effect Sensor
A1324 Hall Effect Sensor
I notice the A1324 Hall Effect Sensor has Arduino crossed out in its description. Is it not compatible with that?
Re: A1324 Hall Effect Sensor
I'm not sure why it has Arduino crossed out - I'll investigate when I get time. The sensor works best at 5 volts, but will work down to 3.3 volts with reduced accuracy.
All and all a fabulous linear output hall-effect sensor.
Paul
All and all a fabulous linear output hall-effect sensor.
Paul
Re: A1324 Hall Effect Sensor
Ok did you happen to figure out if it will work. I did order one called 1308 from somewhere that’s linear but don’t know much about it’s difference with this one
Re: A1324 Hall Effect Sensor
The A1324 will work and is dead easy to hook up.
After confirming the pinout (do this twice as I think the datasheet shows the part from the bottom view - always a bad idea IMO), hook up power and ground and run the output into an ADC (analog) pin.
Paul
After confirming the pinout (do this twice as I think the datasheet shows the part from the bottom view - always a bad idea IMO), hook up power and ground and run the output into an ADC (analog) pin.
Paul
Re: A1324 Hall Effect Sensor
Awesome thank you so much for your help. I ordered them and will put them to use soon!