Using the latest iteration of the Wind Sensor Rev P, I connected the sensor to a 9V input supply, with the correct GND pin connected. On the output pin, for no wind and ambient temp of 75deg (farenheit) I measure an output voltage close to 1.5v
Is this correct? I would think that no air flow would result an output voltage closer to 0. Does the output voltage saturate at 3.3V or 5V ?
Wind Sensor Rev P - output voltage with no wind
Re: Wind Sensor Rev P - output voltage with no wind
rio_schad ,
The Rev P will actually saturate at closer to 7 volts but this will be with wind speeds upwards or 100 mph
PB
The Rev P will actually saturate at closer to 7 volts but this will be with wind speeds upwards or 100 mph
PB
Wind Sensor Rev P output voltage with no wind
Hi all,
I want to design a PH datalogger with these specifications: the output value voltage of PH sensor is input of ADC -> software -> change into hexa -> display this value. I want to know the range of measured voltage of PH sensor and it is linear with voltage or not.
Best regards,
I want to design a PH datalogger with these specifications: the output value voltage of PH sensor is input of ADC -> software -> change into hexa -> display this value. I want to know the range of measured voltage of PH sensor and it is linear with voltage or not.
Best regards,