current sensors

Questions about Modern Device and JeeLabs Sensors
Post Reply
Posts: 1
Joined: Sat May 14, 2016 9:52 am

current sensors

Post by avgreg46 » Sat May 14, 2016 10:00 am

i was just wondering if anyone has a suggestion for a simple clamp type 120v 0-50amp current sensor that i can use for a 120v on/off switch.

Site Admin
Posts: 752
Joined: Mon May 12, 2008 4:19 pm

Re: current sensors

Post by paul » Fri Dec 02, 2016 6:52 pm


Our sensor will work really well for this (it's really easy to sense 50 amps right through a line cord) but you'll need to hook it up to a solid state relay - and also to some kind of DC power source. It would be fairly easy to hook the output up to a solid state relay without a microcontroller, if you were just looking for go-no go at 50 amps.


Posts: 6
Joined: Wed Sep 20, 2017 7:33 pm

current sensors

Post by Sonovkwf » Wed Oct 04, 2017 7:07 pm

How would one connect multiple current sensors?

I am using two 50 A sensors. One on the output of the alternator and one on the output of the battery. I know I can connect one of them to the EIS and assume the other one will also be connected to the EIS.

Will I be able to monitor both current output information on the HX?

Post Reply