Modern Device Forum

Posted: **Fri Feb 12, 2016 5:08 am**

After uploading a sketch to my Arduino board using an USB cable to my laptop, I can see my Pulse Sensor board got powered up as the red LED got turned on.
However, once I disconnect my USB cable from my laptop and connect to an external portable battery, this module is off as the red LED doesn't light up.
Is there any setting I need to use with external battery for this module with PSO2 sketch?
Thanks

Posted: **Fri Dec 02, 2016 6:56 pm**

nternetizen,

The problem is the power up issue with the I2C lines. Push the reset line on your microcontroller and you should see the sensor power right up.

PB

Posted: **Thu May 18, 2017 12:50 am**

Can you give me a example of a code i would use to get it to stop on red?

Modern Device Forum

How to power up Pulse Sensor using external battery?

How to power up Pulse Sensor using external battery?

Re: How to power up Pulse Sensor using external battery?

How to power up Pulse Sensor using external battery