Wind sensor 'prongs'

Questions about Modern Device and JeeLabs Sensors
Post Reply
id02anfo
Posts: 1
Joined: Wed Nov 12, 2014 7:19 am

Wind sensor 'prongs'

Post by id02anfo » Wed Nov 12, 2014 7:24 am

Hello

I'm using your wind sensor (MD0550) and want to use it inside the casing of a product with the prongs or tines protruding through an aperture in the casing. I'd like the sensor to be as unobtrusive as possible. Can you confirm whether the 2 exterior prongs are required for the functioning of the sensor or are they there for protection (and can therefore be trimmed off)?

Thanks for your help

Post Reply