Burning Bootloader/Uploading Sketches To JeeNode Micro
Posted: Sat Nov 16, 2013 5:40 pm
Has anyone succeeded in burning a bootloader to the JeeNode Micro? I believe I followed the toolchain setup described here:
http://jeelabs.org/2013/03/21/programmi ... 5-at-last/
But I when I try to burn the bootloader, I get an error message:
Error while burning bootloader: missing 'erase.params.verbose' configuration parameter
A screen shot of my Arduino screen is uploaded as an attachment, and hopefully I can also upload a photo of the hardware.
I have a BUB II board set to 3.3v logic which is connected to a JeeNode v6 board. On top of this is the JeeNode flash board. The flash board is connected to the JeeNode Micro.
[attachment=1]Arduino_1.5.4.larger_screen_bootloader_error_jeenode_micro.png[/attachment]
[attachment=0]jeenode_micro_programmer_array_edited_small.jpg[/attachment]
Thanks for any help!
Bob Cochran
Greenbelt, Maryland, USA
http://jeelabs.org/2013/03/21/programmi ... 5-at-last/
But I when I try to burn the bootloader, I get an error message:
Error while burning bootloader: missing 'erase.params.verbose' configuration parameter
A screen shot of my Arduino screen is uploaded as an attachment, and hopefully I can also upload a photo of the hardware.
I have a BUB II board set to 3.3v logic which is connected to a JeeNode v6 board. On top of this is the JeeNode flash board. The flash board is connected to the JeeNode Micro.
[attachment=1]Arduino_1.5.4.larger_screen_bootloader_error_jeenode_micro.png[/attachment]
[attachment=0]jeenode_micro_programmer_array_edited_small.jpg[/attachment]
Thanks for any help!
Bob Cochran
Greenbelt, Maryland, USA