BBB input voltage

Questions and Discussion concerning the Bare Bones Board
Post Reply
Posts: 1
Joined: Fri Feb 27, 2009 12:03 pm

BBB input voltage

Post by m_elias » Fri Feb 27, 2009 12:09 pm

I want to clarify how much voltage the regulator can handle on the BBB revD. On page 2 of the pdf instructions it talks about a 5-9V external PS and on the schematic on page 5 it's labeled as 5-12V. I realize that higher voltage and/or higher current equals higher heat dissipation. My application uses very little current. Is 12V the limit or could a guy get away with 15V?

Posts: 93
Joined: Mon Jul 28, 2008 6:52 pm
Location: Western New York, USA

Re: BBB input voltage

Post by floresta » Fri Feb 27, 2009 1:00 pm


The L4931 voltage regulator can handle up to 20v and the 47uF input capacitor (at least the one on my board) is rated at 25v so you should be OK with 15v input. As you mentioned it is the heat that is of concern but most regulators will just shut down if they get too hot. Paul will probably answer you and confirm or correct my diagnosis when he gets back from his day job.


Site Admin
Posts: 769
Joined: Mon May 12, 2008 4:19 pm

Re: BBB input voltage

Post by paul » Sat Feb 28, 2009 1:41 am

Thanks for the reply floresta,

It's all correct - the datasheet says 20V, I just listed 12V because of power dissipation issues and because I like to be conservative. 15V should be fine, but if you start drawing much current from it, it will shut down fairly soon.


Post Reply