Modern Device Forum

Hi dear friends, I want to share with you, this code to test your fluxamasynth shield with the Cubloc 220 Of Comfile technologies... This code works thery well... best regards, Lestroso :D http://www.fasasoftware.com Const Device = CB220 Opencom 1,31250,3,30,20 Putstr 1,240,127,127,4,1,0,127,247 'se...

Hello Friends, Now Here everything works fine!!!! i have solved my problems with fluxamasynt shield..... i have review everything and i have found the solution to work with this board by myself i have used only pin 11 of my cubloc 220 and i have used a resistor of 220 ohm as requested.... i have als...

Is There an Autotest For Testing the Sounds On Fluxamasynth shield???

Hi to everybody....can someone tell me if is there an autotest for this board???

Thanks a lot in advance,

Best regards,

Lestroso

Can someone help me please??? i have tried everything... but this board don't do nothing...neither a little sound.... may be damaged i don't know.... i'm trying to pilot directly with my umx61 with midi out... but nothing works.... i have tryed with my cubloc some command midi like this with a circu...

Dear Paul,

I have sent to you the manual doc about cubloc220.

The language is easy is basic....

I thank you a lot for your time dedicated to me...

i look forward to your reply..

Best Regard,

lestroso (Saverio)

Dear Sirs, It arrived to me the fluxamasynth shield...but i have some problems... 1) I connect my cubloc with p11the serial out...the serial 5v pilot.. to the port number 1 the rx midi in of fluxamasynth...throught a 220ohm resistance, as shown in the manual... For now i have turn on the circuit and...