Search found 5 matches

by Foxbat_25BM
Wed Jul 29, 2020 11:39 am
Forum: Sensors
Topic: Wind Sensor As Hot Wire Microphone
Replies: 6
Views: 7244

Re: Wind Sensor As Hot Wire Microphone

Oh, that's amazing, I can't thank you enough for that! I was looking for iron-nickel wire as tungsten is hard to solder and platinum is too expensive for a hobby project, but couldn't find the right gauge, and here you are with that recommendation. Thanks once again, I'll give feedback as soon as I ...
by Foxbat_25BM
Tue Jul 28, 2020 11:43 am
Forum: Sensors
Topic: Wind Sensor As Hot Wire Microphone
Replies: 6
Views: 7244

Re: Wind Sensor As Hot Wire Microphone

Does the diameter of the wire have to be .0003 for tungsten or nickel-iron wire, too, or is it a platinum-only thing? Because I'm not finding FeNi wire at this size, and the only tungsten I get at this diameter is powder. And of course, I do find the price of the platinum stuff expensive. The thing ...
by Foxbat_25BM
Mon Jul 27, 2020 10:26 am
Forum: Hardware
Topic: A hiss on the Reverbalizer ?
Replies: 8
Views: 3331

Re: A hiss on the Reverbalizer ?

Thanks for the answer! I checked, and yes, there was, in fact, some corrosion inside of the power inlet (I was abroad for a couple months, and it can get pretty damp where I live). I'll see whether it's possible to clean it off and will look into ground loops.
by Foxbat_25BM
Sun Jul 26, 2020 1:05 pm
Forum: Hardware
Topic: A hiss on the Reverbalizer ?
Replies: 8
Views: 3331

Re: A hiss on the Reverbalizer ?

Wait, it looks like there was a problem; that's an admin message, not mine; did I make an error when posting? I was saying that I had a similar hiss and it disappeared after applying Neanderthal tactics (read: I shaked the Reverbalizer). I don't think it's a solder point issue either, could it simpl...
by Foxbat_25BM
Fri Jul 24, 2020 3:05 am
Forum: Hardware
Topic: A hiss on the Reverbalizer ?
Replies: 8
Views: 3331

Re: A hiss on the Reverbalizer ?

I'm more wondering about a bug in programming.
It could be a parts issue - with a pcb board there's not a high chance for poor solder joints (but anything could happen).

If you can reproduce the problem or figure it out I'd like to know

Paul