I see that the buzzer pin might be more problem than it's worth. I'll probably use a piezo unit anyway, not a speaker.
Do the PIC pins correspond to the pins on the DIP chip?
i see 4, 5, and 6 on the silkscreen, but can't seem to find 7. Is it not labeled on the board? Or would I have to take ...
Search found 4 matches
- Tue Jan 17, 2017 3:40 pm
- Forum: Hardware
- Topic: Is the LCD117 able to receive 3.3V logic signals?
- Replies: 8
- Views: 41291
- Sat Jan 14, 2017 4:48 pm
- Forum: Hardware
- Topic: Is the LCD117 able to receive 3.3V logic signals?
- Replies: 8
- Views: 41291
Re: Is the LCD117 able to receive 3.3V logic signals?
I did move forward and use a NPN transistor level shifter with the 3.3V output from the 8266 going to the emitter and the collector going to the 5V Rx on the LCD117.
Now another question. I see in the documentation of the LCD117 and the code examples that there are outputs on the LCD117. I see ...
Now another question. I see in the documentation of the LCD117 and the code examples that there are outputs on the LCD117. I see ...
- Wed Jan 11, 2017 7:51 pm
- Forum: Hardware
- Topic: Is the LCD117 able to receive 3.3V logic signals?
- Replies: 8
- Views: 41291
Re: Is the LCD117 able to receive 3.3V logic signals?
I already have a 5V LCD, and I am using a 5V supply. Can I run the 3.3V TX off my 8266 into the RX on the serial backpack and have it work?
So the three pins on the Serial Backpack:
G - Ground
5V - 5V Power Supply
RX - 3.3V signals from 8266
#1 - Will it work properly? Is the 3.3V enough to be ...
So the three pins on the Serial Backpack:
G - Ground
5V - 5V Power Supply
RX - 3.3V signals from 8266
#1 - Will it work properly? Is the 3.3V enough to be ...
- Mon Jan 09, 2017 12:54 pm
- Forum: Hardware
- Topic: Is the LCD117 able to receive 3.3V logic signals?
- Replies: 8
- Views: 41291
Is the LCD117 able to receive 3.3V logic signals?
I'd like to use an older, through hole LCD117 to display messages from an ESP8266. Seeing that the ESP8266 is 3.3V only, will the LCD117 accept and display Serial print commands at 3.3V?
I'm assuming that I'll still have to power it with 5V, which is fine. I have 5V available, I then use a ...
I'm assuming that I'll still have to power it with 5V, which is fine. I have 5V available, I then use a ...